Used Commercial Kitchen Equipment

Johnson Qvent Stainless Steel 54 Vent Hood / Exhaust Hood

Johnson Qvent Stainless Steel 54 Vent Hood / Exhaust Hood
Johnson Qvent Stainless Steel 54 Vent Hood / Exhaust Hood
Johnson Qvent Stainless Steel 54 Vent Hood / Exhaust Hood
Johnson Qvent Stainless Steel 54 Vent Hood / Exhaust Hood
Johnson Qvent Stainless Steel 54 Vent Hood / Exhaust Hood
Johnson Qvent Stainless Steel 54 Vent Hood / Exhaust Hood
Johnson Qvent Stainless Steel 54 Vent Hood / Exhaust Hood

Johnson Qvent Stainless Steel 54 Vent Hood / Exhaust Hood
54" Exhaust Hood with Two Stainless Steel Grease Filters and 13" Duct. Hood With this Type II application; there are no requirements for all welded liquid tight ducts with rated shaft-wall enclosures, fire suppression systems or specific duct transport velocities. We nonetheless stipulate all Type I materials and methods short of fire extinguishment equipment and rated shafts. When installed in accordance with these instructions the ducts can be pressure washed as needed without leakage or damage to adjacent environmental surfaces. Our Best Design Practice features a hood listed to UL 710, and listed to the NSF/ASNI std 2.

Duct One of the components covered of the system is a 33 length of 18ga MSG liquid tight welded Stainless Steel (SS) duct that will connect to the duct collar. This duct section shall be fastened to the duct collar and then extend up to at least 6 above finished ceiling. A reflective ceiling panel needs to be removed, cut, and then fitted with the (provided) SS escutcheon (frame).

The hood end of the duct (inlet) is then inserted through the frame and fastened to the hoods duct collar. On the discharge end of the duct we are providing some welded angles to enable connection of all-thread hanger rods to provide structural support to the duct and hood.

It is important to have a 1/8-1/4 gap from the bottom of the hood to the top of the oven. The installing contractor shall provide and install the liquid tight duct section that will close from the discharge side of our SS duct section to the UL 762 fan mounted on a 22H hinged curb.

An alternate to the all welded liquid tight 16ga steel duct (or 18ga stainless steel) is the use of a manufactured and UL listed Class A chimney product such as those provided by Metal-Fab, Inc. We Are a Fully Operational Used Restaurant, Bar, and Supermarket Equipment Dealer in GA. We have a forklift and loading dock.

Please call in advance for pick-up arrangements. We except "ALL" types of payments. Thank you for viewing our listing. You may also pay by cash or check if you are picking the item up locally. We do our best to present accurate, detailed information about every item we sell.

Item was described as working and it is not. The item "Johnson Qvent Stainless Steel 54 Vent Hood / Exhaust Hood" is in sale since Tuesday, August 09, 2016. This item is in the category "Business & Industrial\Restaurant & Catering\Commercial Kitchen Equipment\Hood Systems, Fire Suppression". The seller is "gaequipment2013" and is located in Covington, Georgia. This item can be shipped to United States.

  • Brand: Johnson
  • Model: Qvent


Johnson Qvent Stainless Steel 54 Vent Hood / Exhaust Hood